Rpvc Route Set Command; Rpvc Route Show Command; Figure 247 Rpvc Route Set Command Example - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51 User's Guide

50.7.8 RPVC Route Set Command

Syntax:
ras> adsl rpvc route set <port number> <vpi> <vci> <ip>/<netmask>
where
<port number>
<vpi>
<vci>
<ip>
/<netmask>
This command adds a domain for 2684 routed mode traffic. The domain includes the
subscriber's LAN IP addresses.
Note: You must use the
use the
The following example adds a domain for a CPE device is connected to DSL port 1 on the
IES-1248-51 and the 2684 routed mode traffic is to use the PVC identified by VPI 8 and VCI
35. The CPE device's LAN IP address is 10.10.10.10 and uses a subnet mask of
255.255.255.0. This includes the CPE device's LAN IP addresses and the IP addresses of the
LAN computers.

Figure 247 RPVC Route Set Command Example

ras> adsl rpvc route set 1 8 35 10.10.10.1/24

50.7.9 RPVC Route Show Command

Syntax:
ras> adsl rpvc route show <portlist>
354
The port of the RPVC. Specify a single ADSL port <1>.
=
The VPI of the RPVC.
=
The VCI of the RPVC.
=
The subscriber's CPE LAN IP address in dotted decimal
=
notation.
The bit number of the subnet mask of the subscriber's IP
=
address. To find the bit number, convert the subnet mask to
binary and add all of the 1's together. Take "255.255.255.0" for
example. 255 converts to eight 1's in binary. There are three
255's, so add three eights together and you get the bit number
(24).
rpvc gateway set
command.
rpvc route set
and the commands before you
rpvc set
Chapter 50 Virtual Channel Management