Table 46 2684 Routed Domain - ZyXEL Communications IES-1248-51 User Manual

The following table describes the labels in this screen.

Table 46 2684 Routed Domain

LABEL
RPVC ARP Proxy
Routed Gateway
Routed PVC
Port
VPI
VCI
IP
NetMask
Add
Cancel
Index
Port
VPI
VCI
IP
NetMask
Delete
Cancel
Chapter 28 2684 Routed Mode
DESCRIPTION
Click RPVC ARP Proxy to go to the screen where you can view the Address
Resolution Protocol table of IP addresses of CPE devices using 2684 routed
mode and configure how long the device is to store them (see
page 186).
Click Routed Gateway to go to the screen where you can configure gateway
settings (see Section 28.5 on page
Click Routed PVC to go to the screen where you can configure routed PVC
settings (see Section 28.2 on page
Use this drop-down list box to select a port for which you wish to configure
settings.
Type the Virtual Path Identifier for this routed PVC.
Type the Virtual Circuit Identifier for this routed PVC. The IES-1248-51 uses this
PVC channel internally.
Enter the subscriber's CPE LAN IP address in dotted decimal notation.
The bit number of the subnet mask of the subscriber's IP address. To find the bit
number, convert the subnet mask to binary and add all of the 1's together. Take
"255.255.255.0" for example. 255 converts to eight 1's in binary. There are three
255's, so add three eights together and you get the bit number (24).
Click Add to save your changes to the IES-1248-51's volatile memory.
The IES-1248-51 loses these changes if it is turned off or loses power, so use
the Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to start configuring the screen again.
This field displays the number of the routed PVC.
This field displays the number of the ADSL port on which the routed PVC is
configured.
This field displays the Virtual Path Identifier (VPI) The VPI and VCI identify a
channel on this port.
This field displays the Virtual Circuit Identifier (VCI). The VPI and VCI identify a
channel on this port.
This field displays the subscriber's IP address.
This field displays the bit number of the subnet mask of the subscriber's LAN IP
address.
Select an entry's Delete check box and click Delete to remove the entry.
Clicking Delete saves your changes to the IES-1248-51's volatile memory.
The IES-1248-51 loses these changes if it is turned off or loses power, so use
the Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to start configuring the screen again.
IES-1248-51 User's Guide
186).
182).
Section 28.4 on
185