Procedure To Connect To An Mdf; Installation Scenario B; Figure 17 Installation Scenario A; Figure 18 One Mdf For End-User And Co Connections - ZyXEL Communications IES-1248-51 User Manual

Adsl+ ip dslam

Hide thumbs Also See for IES-1248-51:

Table of Contents

IES-1248-51 User's Guide

4.6.1.1 Procedure to Connect to an MDF

1 Connect the Telco-50 connector end of the cable to the Telco-50 connector labeled

2 Connect the wiring on the other end of the Telco-50 cable to the upper ports of the MDF

using a punch-down tool.

3 Connect the telephone wiring from each end-user's DSL modem to the lower ports of the

Phone service is available. There is one MDF from which end-users CO connections are made

(see the next figure).

This installation scenario requires three MDFs. Please see the following figure for the

connection schema.

Chapter 4 MDF Connections