System Administrator; Connecting To The Telephone Entry System From A Remote Location; Relay Check; Time And Date Check - DKS 1834 PC Programmable Installation & Owner's Manual

5.3 System Administrator

The administrator can perform the following operations from a remote location using a touch tone telephone. You must know
the phone number of the system and the system master code. The system MUST be setup to accept incoming calls, see
sections 3.1 and 4.6.

5.3.1 Connecting to the Telephone Entry System from a Remote Location

1. Call the telephone number that the entry system is installed on. The system will answer with a short tone (beep) after two rings.
2. Press 16 and enter the four-digit MASTER CODE _ _ _ _ (beep). The beep indicates system has accepted master code.
*
3. Press the desired tone open number _ (beep).
Note: Refer to section 3.3.3 to determine which tone open features have been programmed, i.e. momentary open, hold open,
release, hold open one hour and then release.
4. Hang up.

5.3.2 Relay Check

The telephone entry system can be called and a check can be made to determine if any of the relays in the system are in a "hold
open" mode. This check can be useful if your gate (or door) is held open and you suspect that the telephone entry system relay
may be the cause.
1. Call the telephone number that the entry system is installed on. The system will answer with a short tone (beep).
2. Press 16 and enter the four-digit MASTER CODE _ _ _ _ (beep).
*
3. The system will emit a series of short tones if the relay is in a continuous activation mode:
Relay 1 activated: beep - pause - beep - pause . . .
Relay 2 activated: beep beep - pause - beep beep - pause . . .
Relay 0 activated: beep beep beep - pause - beep beep beep - pause . . .
Note: Relay 0 is Not available for the 1834.
4. Press the programmed tone number _ to deactivate the relay (beep). The system will automatically hang up.

5.3.3 Time and Date Check

This operating functions lets you check the current date, time and day of the week that the system is currently programmed to.
If the calendar chip in the system is NOT programmed, the system will emit a long beeeeeep when this function is entered on
the telephone entry system keypad.
Note: The calendar chip can ONLY be programmed by the PC when communication is established either by modem or the
RS-232 terminal.
1. Press 30 and enter the four-digit MASTER CODE _ _ _ _ (beep).
*
The LCD display will show: The date - Month / Day / Year
This information will be displayed for approximately four-seconds, then the LCD display will return to normal.
1834-065-B-10-14
The time - Hours / Minutes / AM or PM (AM=0, PM=1)
The day of the week (1=Sunday, 7=Saturday).
45