Area Codes; Phone Numbers With Area Code Reference; Deleting Individual Phone Numbers - DKS 1803 Owner's Manual

3.2.3 Programming Area Codes
Up to 10 different area codes can be programmed for any 10-digit or long distance calling
requirements and will be referenced 0 through 9 (for a total of 10). The area codes will be entered as
a four-digit number (1 + the three digit area code). If area codes are being programmed to facilitate
10-digit calling requirements, precede the three-digit area code with #.

1. Press
2. Enter the area code reference number (0 through 9)
3. Enter the area code
requirements, enter 1 and the three-digit area code. NOTE-2: for 10-digit calling
requirements, enter # and the three-digit area code.
4. Repeat steps 2 and 3 to enter additional area codes. Remember to use a different
area code reference number when entering more area codes.

5. Press TOGETHER to end this programming step (beeeeeep).
3.2.4 Programming Phone Numbers with Area Code Reference
In this section, phone numbers that are referenced to an area code (long distance and 10-digit dialing
calls) will be programmed. Be sure that the area code(s) have been programmed as described in the
preceding section.
NOTE: If long distance or 10-digit dialing is not required, program the seven digit telephone
numbers as described in 3.2.2.

1. Press
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.2.1) then press
3. Enter the area code reference number
4. Enter the seven-digit phone number
number that you are entering in this step is less than seven-digits, enter # in the
empty spaces. For example, if the system is connected to a PBX that requires four-
digit extension numbers and you want to enter extension 2217, you would enter this

number as
5. Repeat steps 2, 3, and 4 to enter additional long distance phone numbers.

6. Press TOGETHER to end this programming step (beeeeeep).

3.2.5 Deleting Individual Phone Numbers

This programming sequence is used to delete a single phone number under a known directory code.

1. Press
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.2.1) then press

3. Press
4. Repeat steps 2 and 3 to delete additional phone numbers.

5. Press TOGETHER to end this programming step (beeeeeep).
and enter the four-digit MASTER CODE
BBBB
then press
and enter the four-digit MASTER CODE
(beep).
then press
and enter the four-digit MASTER CODE
(beep).
then press (beep).
BBBB
B
then press
(beep). NOTE-1: for long distance calling
BBBB
B
then press (beep).
BBBBBBB
then press
(beep).
BBBB
33
(beep).

EHHS 
(beep).
(beep). If the
(beep).