Table of Contents
Advertisement
PART 10: FRONT CASTING ASSEMBLY & FINAL REVIEW
Front casting assembly for model 527 (See fig. 44)
• Remove the nut from the threaded stud on
• Locate the brass bar in the slots at the top of
• Insert the threaded studs through the holes
• Fit the nuts to the studs underneath the
• Place the front casting unit between the sides
Final review
•
•
•
•
•
•
•
•
24
the brass finials
the front casting.
at the top of the casting to trap the brass bar
in position
casting and tighten.
of the front surround and place the bottom
front casting underneath.
Hand these instructions and the owner's
guide and the smoke match tube to the
customer.
Visually inspect the appliance. Clean off any
marks incurred during installation.
Advise the customer how to operate the appliance.
Explain to the customer that the appliance has a flame failure & spillage monitoring
system. Point out the explanation of this system shown in the owner's guide under
"Operating the Fire. Advise that if the fire goes out for any reason, wait at least
three minutes before relighting.
Stress that if the monitoring system repeatedly shuts off the fire, the appliance
should be switched off and a specialist should be consulted.
Advise the customer that the castings, front surround, firebox and ceramic pieces
can be cleaned as described in the user's instructions and that the coal pieces must
be replaced as described in those instructions.
Stress that no extra coals must be added over and above those supplied with the
appliance and that any replacements must only be the authorised spares. Warn that
ignoring this advice could cause incomplete clearance of the products of combustion
with consequent health hazards.
Recommend that the appliance should be serviced by a competent person at least
annually.
Fig. 44
Hide quick links:
Advertisement
Table of Contents
