Final Review - Valor 4190 Installer's Manual

Fig. 34 Fire front casting location

12 FINAL REVIEW

12.1 Fit the fire front casting to the front surround. Locate the two screw
heads at the rear top corners of the casting through the keyhole slots at the
inner sides of the surround. If the screw heads do not project enough or
project too far, the screws can be adjusted. Lower the casting so that it rests on
the hearth (see figure 34).
12.2 Place the bottom front cover casting in position below the fire front
casting.
12.3
Visually inspect the appliance. Clean off any marks incurred during
installation.
12.4 Hand these instructions and the user's instructions to the customer.
12.5 Advise the customer how to operate the appliance. Point out that
lighting instruction details are on the metal plate attached at the bottom of the
appliance (Leave the plate visible in front of the bottom front cover as a
reminder.
12.6 Explain to the customer that the appliance has a flame failure & spillage
monitoring system. Point out the explanation of this system shown in the users
instructions under "Operating the fire".
Advise that if the fire goes out for any reason, wait at least three minutes before
relighting.
Stress that if the monitoring system repeatedly shuts off the fire, the appliance should
be switched off and a specialist should be consulted.
12.7 Advise the customer that they should read their Owner's guide before operating
the fire and always follow the advice in the section headed "Cleaning".
12.8 Stress that no extra coals must be added over and above those supplied with the
appliance and that any replacements must only be the authorised spares. Warn that
ignoring this advice could cause incomplete clearance of the products of combustion with
consequent health hazards.
12.9
Recommend that the appliance should be serviced and the chimney inspected by
a competent person at least annually.
22