Standby Button - Emotiva XMC-1 User Manual

XMC-1 Remote Control
1
STANDBY DIM
2
INPUTS
3
TUNER 1
4
4 5
5
MODE
MUSIC MOVIE
6
7
SELECT
INFO
8
9
CENTER SUB
TRIMS
10
POWER VOLUME
ZONE 2
11
AM/FM STATION
TUNER
Note: The Mode selector buttons will only allow you to select modes that are valid for the
particular input and source content you have selected. When playing DVD and Blu-Ray discs,
your player and the disc itself may offer a choice of several audio modes. After you select this
output audio format, the XMC-1 will determine which type of audio is being supplied by your
source component, and will oNly allow you to choose audio modes that are compatible with
that input signal.
Connecting the XMC-1
12
MUTE ON
13
2 3
6 7
14
INPUT VOLUME
15
LOUDNESS SPEAKER
PRESET
16
MENU
17
SURR BACK
18
INPUT
19
SEEK TUNE
1. Dim Button
Press the Dim button once to display the current
Brightness setting; then, press the button
repeatedly to adjust the Brightness setting of
the XMC-1 front panel display; each subsequent
press advances the Brightness one level; if the
Brightness is at 100%, the next button press
returns it to 0%. (Brightness can be adjusted in six
steps: 0%, 20%, 40%, 60%, 80%, 100%).

2. Standby Button

Press the Standby button to switch the XMC-1
from On to Standby mode.
3. Direct Input Selector Buttons
Press one of the Direct Input Selector buttons to
switch the XMC-1 directly to a specific input.
Note: Buttons are assigned to specific inputs
using the setup Menu.
4. Input Selector Buttons
Use the Input Selector buttons to cycle through
the entire list of available inputs on the XMC-1.
Note: only Inputs configured as Visible on the
setup Inputs Menu will be shown here.
5. Mode Selector Buttons
Use the Mode Selector buttons to cycle through
the available modes for the input you have
selected.
Page 78