Emotiva XMC-1 User Manual page 69

Connecting the XMC-1
Note: When playing DVD and Blu-Ray discs, your player and the disc itself will probably offer
you a choice of several audio modes. After you select one, the XMC-1 will determine which type
of audio is being supplied by your source component, and will oNly allow you to choose audio
modes that are compatible with that input signal. (for example, if you select "Dolby Digital"
when playing a disc, the XMC-1 will offer you digital surround options compatible with that
mode, but NoT modes which are not compatible with it.)
11. Info Button
Press this button to cause the information from the XMC-1 front panel display to show
momentarily on the OSD. (You can also use this button to momentarily "light" the front panel
display if Brightness is set to 0%.)
12. Direct Input Selector Buttons
Each of these buttons can be used to immediately select a configured input.
Note: The front Button lock in the setup | Advanced Menu is intended to prevent settings on the
XMC-1 from being inadvertently changed (and also acts as a "child lock"). If you accidentally
become locked out of the XMC-1 by disabling all controls, you can override this feature and
access the setup Menu by holDING ThE ENTER BUTToN DoWN WhIlE pREssING ThE MENU
BUTToN (both on the front panel).
Note: By certain combinations of settings, it is possible to end up in a situation where you
must press the standby button to turn your XMC-1 on, but both the front panel buttons and
the remote control have been disabled. If this happens, you may override the lock on the
front panel controls and turn your XMC-1 on by holDING ThE ENTER BUTToN DoWN WhIlE
pREssING ThE sTANDBy BUTToN (both on the front panel).
Page 63