Menu Navigation Buttons - Emotiva XMC-1 User Manual

Connecting the XMC-1
6. Music & Movie Mode Buttons
Press the Music or Movie Mode button to select that setting in the decoder. (This will set the
Dolby or DTS decoder to use the mode option you select. The audible result will be slightly
different depending on what mode you are in.)

7. Menu Navigation Buttons

Use the Select Button (center), and the Up, Down, Left, and Right buttons for navigating the front
panel and on-screen menus.
8. Info Button
If the Info screen is already displayed on the XMC-1 front panel display, pressing the Info button
will cause the Info screen to display momentarily on the OSD. If the Menu screen is displayed on
the XMC-1 front panel, pressing the Info button will cause the Info screen to display momentarily
on both the front panel display and the OSD (you will be returned to the Menu screen when the
Info screen times out).
9. Trims Adjustments
Use the Trims Adjustment buttons to temporarily adjust the levels on specific sets of speakers.
Note: These Trims are used to make temporary adjustments to speaker levels; for example,
to adjust the levels for a particular movie or disc. since these settings are intended to be
temporary, they are NoT retained when you switch Inputs or change speaker presets, and they
are NoT retained when the XMC-1 is restarted. To make changes to speaker levels which will be
retained, use the levels settings in the speakers preset section of the setup Menu.
10. Zone 2 Power Button
Use the Zone 2 Power button to turn Zone 2 On and Off. Pressing this button once turns Zone 2
On; pressing it again turns Zone 2 Off.
Note: pressing the Zone 2 power button will turn Zone 2 on, even if the XMC-1 is in standby
mode, and even if the XMC-1 is configured to use its lowest power standby mode. however, if
you turn on Zone 2 while the Main Zone is off, and while the XMC-1 is in lowest power standby
mode, there will be a delay while the XMC-1's operating system is loaded. you can avoid this
delay by configuring your XMC-1 to use Video on standby mode.
11. Tuner Control Buttons
Note: once you have used the Tuner Direct Input button to select the XMC-1 tuner, the Tuner
Control buttons control operation of the tuner.
Press the AM/FM button to toggle between the AM and FM bands. Press the Station Up or Station
Down button to move to the previous/next preset station. Press the Seek Up or Seek Down button
to instruct the XMC-1 to seek to the previous/next received station. Press or hold the Tune Up or
Tune Down button to instruct the XMC-1 to manually seek a station by tuning up or down the
frequency band.
Page 79