Front Panel; Standby Button - Emotiva SA-250 User Manual

Front Panel

Front Panel
1 2
3

1. standby Button

Press this button to switch the SA-250 from Standby to On; press it again to return to Standby.
Note: for the sA-250 to operate, the rear panel AC power switch must be on.
2. standby Indicator lED
This LED illuminates red when the SA-250 is in Standby; blue when the SA-250 is On;
and flashes red when a fault condition occurs.
3. Channel status Indicator lEDs
These LEDs display the status of each amplifier channel in the SA-250. Channel Status LEDs
illuminate red briefly during startup; steady blue for normal operation; and blinking red to
indicate a channel fault.
Note: The status lEDs can be disabled by the status lEDs switch on the rear panel.
Note: To reset a fault indication, switch the sA-250 into standby, then back to on. If the fault
returns, see the Troubleshooting section for more suggestions.
Page 7