Firmware Update - Emotiva XMC-1 User Manual

The XMC-1 Menu System
Front IR In
Check this box to disable the front panel IR Input.
Note: When the front panel IR Input is disabled, the remote control will NoT function unless an
external IR remote sensor ("eye) is used.
Standby
Use this option to enable the XMC-1's Video on Standby feature.
Selecting Video Remains on will configure the XMC-1 to use its Video on Standby Mode. When
this mode is selected, the XMC-1 will continue to pass video and audio from the selected input
source to the display, and will allow you to change the Input source, even when the XMC-1 is in
Standby Mode. The XMC-1 uses slightly more power when in Standby Mode if Video on Standby
Mode is enabled.
Selecting lowest power will configure the XMC-1 to use its lowest power Standby Mode. In this
mode, video and audio will NOT be passed to the display when the XMC-1 is in Standby Mode.
Note: When the XMC-1 is set to Video on standby Mode, the XMC-1 operating system remains
loaded when the XMC-1 is in standby Mode. Because a significant portion of the start up time
on the XMC-1 is used to load the operating system, setting the XMC-1 to use Video on standby
Mode will considerably shorten the amount of time it takes the XMC-1 to wake up from standby
Mode.
Note: The start-up sequence on the XMC-1 is different depending on which standby Mode you
have configured the XMC-1 to use.
In lowest power Mode, turning the XMC-1 on using the rear panel power switch will cause it
to immediately enter standby Mode (halo ring around the standby button lit amber). pressing
the standby button will then cause the XMC-1 to load the XMC-1 operating system and turn
fully on. The XMC-1 operating system is loaded during this start up sequence, which may take
up to one minute. pressing the standby button when the XMC-1 is on will cause it to return to
standby Mode (and unload the operating system).
In Video on standby Mode, turning the XMC-1 on using the rear panel power switch will cause
it to first load the XMC-1 operating system, then return to standby Mode. (While the operating
system is loading, the halo ring around the standby button will illuminate blue. once the
operating system is loaded, the XMC-1 will drop into standby Mode and the halo ring will
change to purple.) since the operating system remains loaded while the XMC-1 is in standby
Mode, switching between on and standby Mode can then be accomplished very quickly.)

Firmware Update

Selecting Firmware Update instructs the XMC-1 to load a firmware update from the inserted USB
stick. After selecting Restore Config you will be prompted to Confirm your choice.
Page 49