Emotiva XMC-1 User Manual page 48

The XMC-1 Menu System
LFE Level
The LFE Level control allows you to adjust the level for the LFE channel for all inputs from 0 dB to
-20 dB in 0.5 dB increments.
Turn-On Input
The Turn-On Input setting allows you to configure which Input on your XMC-1 is active when you
first turn it on. If you select Last Used, then the input which was in use when the XMC-1 was shut
down will be chosen.
Turn-On Volume
The Turn-On Volume setting allows you to configure the Volume Level your XMC-1 will default to
when first turned on. Choices are -10 dB, -20 dB, -30 dB, -40 dB, -50 dB, -60 dB, and Last Used; if
you select Last Used, then the Volume Level will return to where it was when the XMC-1 was shut
off.
Max Volume
The Max Volume setting allows you to configure the maximum Volume Level which can be
selected from the front panel Volume knob or the Volume buttons on the remote control. This
setting controls the Volume setting in the Main Zone, and can be set from -30 dB to +11 dB in
1 dB increments.
Note; The Max Volume setting is a safety feature intended to prevent you (or other users) from
accidentally turning the Volume on your XMC-1 up too high; it does NoT prevent level Trims
from raising the overall level or gain of the XMC-1, or specifically limit input or output levels.
Front Brightness
The Front Bright control configures the brightness of the XMC-1's front panel OLED display.
Display brightness can be set to 0, 20, 40, 60, 80, and 100. If the Front Bright is set to 0, then the
front panel display will be entirely dark. If the Front Bright is set to 0, when the user makes an
adjustment or operates a control the display will momentarily brighten so the results are visible,
then return to full dark after a few seconds.
OSD Transparency
The OSD Transparent control configures the transparency of the XMC-1's OSD (on-screen display).
Transparency can be set from 0% to 70% in 5% increments.
Page 42