Emotiva XMC-1 User Manual page 52

setup | Network Menu
Setup
Network
(menu)
DHCP
If DHCP is selected, then the XMC-1 will obtain all network setup parameters from your local
DHCP Server. If you have a cable modem or router, then it probably also provides a DHCP Server
for your home network. If your network doesn't have a DHCP server, or you wish to set up the
network configuration of your XMC-1 manually, then disabling the DHCP check box will allow you
to set each parameter manually.
Note: Most users will find DhCp the best choice. If you prefer to configure your XMC-1 network
parameters manually, please consult your network service provider or local computer expert
about the appropriate addresses and subnet mask to enter.
Note: If you disable DhCp in the XMC-1's configuration after the XMC-1 has obtained network
settings via DhCp, the settings already obtained will NoT be cleared. This can be used as a
handy shortcut for manually configuring the network settings in your XMC-1; simply allow the
XMC-1 to fill in all the network settings via DhCp, then disable DhCp and manually modify only
the settings you wish to change.
The XMC-1 Menu System
DHCP
DNS 1
DNS 2
Gateway
Subnet
Mask
IP
Address
Page 46
The setup Network Menu
allows you to configure
various network parameters
for the XMC-1.
Note: The XMC-1's Ethernet
connection is used to
connect the XMC-1 to the
Internet via your home
network. An Internet
connection is required in
order to configure DIrac
live automatic room
correction, and to allow
Ethernet-based or Internet-
based remote control
apps to connect to the
XMC-1. once Dirac live
is configured, the XMC-1
does NoT need to remain
connected to the Internet
- or your local network - to
operate.