Table of Contents
Advertisement
supports 1 area for detection. Click area to select this area, click again to deselect.
Click [Clear all] button to clear all detection areas.
Click [Clear select] button to clear selected detection area.
Click [Setup] button to save the setting.
When the setting is not saved, click [Query] button to return to the previously saved
parameters; when the setting has been saved, click [Query] button to query whether
the setting is successful.
Click close button to exit current interface.
[Alarm Schedule]: Enable this function, user can set a daily schedule of motion detection.
The start time should be earlier than the end time. You can copy and apply time settings to
the other date or every day. Click OK button to save your settings, click Refresh button to
update the schedule.
[Output]: Linkage alarm output with built-in relay when alarm is triggered.
[Delay]: The duration of linkage alarm output when alarm is triggered, range from 1 to
10s.
[Record]: Linkage recording and store in the SD card when alarm is triggered.
[Linkage Mode]: The duration of linkage recording when alarm is triggered, time range:
5/10/30/60/120/300/600/900/1200/1800s.
[Capture]: Linkage capture and store in the SD card when alarm is triggered.
[E-mail]: Enable this function, the alarm information of motion detection will be sent to
mailbox (refer to E-mail Configure). The notification email can contain text messages and
images.
[FTP]: Enable this function, the alarm information of motion detection will be saved in FTP
Server. User can upload text messages and images.
Click OK button to save the setting; when the setting is not saved, click "Refresh"
button to return to the previously saved parameters; when the setting has been saved,
click "Refresh" button to query whether the setting is successful.
IP Camera User Manual
27
Advertisement
Table of Contents
