Multi-Sheet Feeding - Formax FD 38Xi Operator's Manual

MULTI-SHEET FEEDING

The multi-sheet feeder is designed to fold pre-collated stapled or unstapled sets of up to four 20 # (75gsm)
sheets of paper. You may need to create a custom fold, depending on the thickness of the finished multi-sheet
set.
1.
Select the fold type and paper size (see page 6). The
Multi-Sheet Feeder accommodates 11" and 14" paper
lengths.
Adjust the side guides on the multi-sheet feeder for
the proper paper size. Loosen the brass thumb screw,
adjust the guides to fit the paper width and re-tighten
the thumbscrew (Fig 47a).
2. Slide the pre-collated paper set into the multi-sheet
feeder. When feeding stapled sets the documents
should be placed with the staple on the operator's
side and leading (Fig 47b).
3. The sheets of paper will be automatically pulled into
the folder (there is a one-second delay after the paper
is placed in the feeder).
4. If the fold is skewed, turn the skew adjustment knob
located on the back of the feeder left or right to make
corrections (Fig 47c).
5.
To remove the multi-sheet feeder, depress the release
levers located on either side of the lower back side of
the feeder (Fig. 47d), tilt the feeder forward and lift.
To reinstall depress the levers and reinsert.
Fig. 47a
Fig. 47b
Fig 47c
Fig. 47d
19
Brass thumbscrew
Staple
Skew Adjuster
Release Levers