Reinstalling The Top Cover; Reinstalling The Front Panel - HP 6000 SERIES Hardware Installation Manual

Hardware Installation Manual
HP Series 6000
Reinstalling the Top Cover
1. Slide the top cover down over the mass storage system chassis so that the
back of the top cover extends one-half inch beyond the rear of the mass
storage system chassis (see Figure 1-3), then slide the top cover forward into
place.
2. Install and tighten the T15 top cover screws.
Reinstalling the Front Panel
1. Insert the front panel mounting tabs into the slots in the top cover and swing
the front panel down until the (LlNE~) switch comes through the opening in
the front panel (see Figure 1-3).
2. Push the bottom edge of the front panel into the front of the chassis until
the front panel locking tabs engage.
3. Reconnect the SCSI cable and the power cord to the mass storage system rear
panel.
1·18 Mass Storage System