Config Igmp_Snooping Querier; Config Router_Port - D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
Restrictions
Example usage:
To configure the igmp snooping:

config igmp_snooping querier

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the igmp snooping:

config router_port

Purpose
Syntax
Description
115
seconds.
leave_timer <sec 0-16711450> − Leave timer. The default is 10
seconds.
state [enable | disable] − Enables or disables IGMP snooping for the
specified VLAN.
Only administrator or operator-level users can issue this command
DGS3100# config igmp_snooping default host_timeout 250 state enable
Success.
DGS3100#
To configure IGMP snooping querier on the Switch.
config igmp_snooping querier [vlan <vlan_name 32> | all] state
[enable | disable] {querier_version [IGMPv2 | IGMPv3]}
The config igmp_snooping querier command enables IGMP
snooping querier on a specific VLAN.
<vlan_name 32> − The name of the VLAN for which IGMP snooping
is to be configured. Up to 32 characters can be used.
all – Specifies that IGMP snooping is to be configured for all VLANs
on the Switch.
state [enable | disable] − Enables/Disables IGMP Snooping Querier.
querier_version [IGMPv2 | IGMPv3] − Specifies the IGMP Querier
version on the VLAN.
Only administrator or operator-level users can issue this command
DGS3100#config igmp_snooping
querier_version IGMPv2
Success.
DGS3100#
To configure ports as router ports.
config router_port <vlan_name 32> [add | delete] <portlist>
The config router_port command designates a range of ports as
being connected to multicast-enabled routers. This ensures all
packets with such a router as its destination will reach the multicast-
all state enable