Port Security Commands - D-Link DGS-3100 SERIES Cli Manual

The Port Security commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
config port_security
show port_security
Each command is listed in detail, as follows:

PORT SECURITY COMMANDS

Parameter
[<portlist> | all] {admin_state [enable | disable] | max_learning_addr <int 1-64> |
lock_address_mode [Permanent | DeleteOnTimeout | DeleteOnReset] | trap <1-
1000000>}
{<portlist>}
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
21
140