Config 802.1P User_Priority - D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
Syntax
Description
Parameters
Restrictions
Example usage:
T o display the bandwidth control configuration:

config 802.1p user_priority

Purpose
Syntax
Description
91
show bandwidth control [<portlist> | all]
The show bandwidth_control command displays bandwidth
control.
portlis t– A port or range of ports to be configured.
all – Specifies that the show bandwidth_control command applies
to all ports on the Switch.
None.
DGS3100# show bandwidth_control all
Bandwidth Control Table
Port RX Rate TX Rate
–––– ––––––––––––– –––––––––––––
1 no_limit no_limit
2 no_limit no_limit
3 no_limit no_limit
4 no_limit no_limit
5 no_limit no_limit
6 no_limit no_limit
7 no_limit no_limit
8 no_limit no_limit
9 no_limit no_limit
10 no_limit no_limit
11 no_limit no_limit
12 no_limit no_limit
13 no_limit no_limit
14 no_limit no_limit
15 no_limit no_limit
16 no_limit no_limit
17 no_limit no_limit
Total entries : 17
DGS3100#
To map the 802.1p user priority of an incoming packet to one of the
four hardware classes of service available on the Switch.
config 802.1p user_priority <priority 0-7> <class_id 0-3>
The config 802.1p user_priority command configures the way the
Switch maps an incoming packet, based on its 802.1p user priority
tag, to one of the four hardware priority classes of service available
on the Switch. The Switch's default is to map the incoming 802.1p
priority values to the four hardware classes of service according to
the following chart: