Initializing An Sd Card; Setting The Automatic Power Save Function - Nikon P-400R Instructions Manual

7.5

Initializing an SD Card

You can use the P-400R to initialize the SD card inserted in the P-400R.
1 Display the [Setup menu] screen.
2 Select [SD card format], and then press
the [OK] (or right) button.
The [SD card format] screen appears, and
then a confirmation message appears.
3 Use the top and bottom buttons of the
multi-selector to select [Format] or [No],
and then press the [OK] (or right)
button.
If [Format] is selected, the SD card is
initialized, and a folder named 100NIKON
is created in the DCIM folder.
The [Setup menu] screen appears again.
7.6

Setting the Automatic Power Save Function

The P-400R has the automatic power save function, which automatically places the
P-400R in standby mode if no operation is performed for a length of time. The
following shows to procedure for enabling this function and specifying the time.
1 Display the [Setup menu] screen.
2 Select [Auto off], and then press the
[OK] (or right) button.
The [Auto off] screen appears.
3 Use the top and bottom buttons of the
multi-selector to set the no-operation
time period after which the P-400R is
placed in standby mode.
 At each capturing, 30s, 1m, 5m, 10m,
20m (initial setting: 1m)
(s: seconds, m: minutes)
4 Press the [OK] (or right) button to apply
the selection.
The [Setup menu] screen appears again.
P-400R Digital Microscope Instructions
77
7