Nikon P-400R Instructions Manual page 16

WARNING
1. Never disassemble, repair, or modify the battery charger.
Doing so may cause an electric shock or personal injury.
2. If the inside of the battery charger is exposed due to breakage, never
touch the exposed area.
Doing so may cause an electric shock or personal injury on the jagged
broken edge. Disconnect the power cord from the outlet and ask your
nearest Nikon representatives for repair.
3. If you notice any abnormality such as overheating, smoke, or burnt
odor, immediately pull out the power cord from the outlet.
Otherwise, the battery charger may ignite, leading to fire. Be careful not to
burn yourself when you pull out the battery charger's power cord from the
outlet. Ask your nearest Nikon representative for repair.
4. Do not allow the battery charger to become wet.
Doing so may cause electrical shock or fire.
5. Do not handle the battery charger when your hands are wet.
Doing so may cause malfunction or electrical shock.
6. Never use the battery charger in a flammable or combustible
environment.
Using it in a combustible gas or dust environment may cause an explosion
or fire.
7. Clean off any dust on and around the metallic part of the power plug
with a dry cloth.
Otherwise, continued use may cause fire.
8. Check the input voltage.
The battery charger operates on 100 to 240 VAC, 50/60 Hz power supply.
Before connecting the power supply, confirm that the voltage and
frequency of the power supply line to use are within the above range.
Using a power supply line that does not satisfy the rating may cause
failure or malfunction of the equipment or fire.
9. Use the power cord supplied with the battery charger.
Use the supplied power cord without fail. If any other power cords are
used, it may cause malfunction or overheating of the equipment or fire.
Do not connect the power cord supplied with the battery charger to any
other devices.
CAUTION
1. Never put a cloth over the battery charger during use.
Heat accumulated under the cloth may deform the case or cause fire.
2. Pull out the power cord when the battery charger is not used.
Otherwise, electric shock may occur.
P-400R Digital Microscope Instructions
(for the battery charger)
(for the battery charger)
xiv