Installing A Microprocessor Retention Module - Lenovo ThinkServer TD200x Hardware Maintenance Manual

Installing a microprocessor retention module

To install a microprocessor retention module, complete the following steps:
1. Orient the triangle-shaped indicator on one corner of the microprocessor
2. Using a T8 Torx screwdriver, install the four screws that secure the module to
3. Install the microprocessor and heat sink (see "Installing a microprocessor and
4. Install the air baffle (see "Installing the air baffle" on page 172).
5. Return the power-supply cage to its closed position (see "Closing the
6. Install the power supplies (see "Installing a hot-swap power supply" on page
7. Install and lock the left-side cover (see "Installing the left-side cover" on page
8. Reconnect the external cables and power cords; then, turn on the attached
232
ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Hardware Maintenance Manual
retention module to the corresponding alignment triangle on the system board;
then, place the retention module on the system board.
the system board.
heat sink" on page 222).
Attention: Make sure that you install each heat sink with its paired
microprocessor.
power-supply cage" on page 162).
177).
160).
devices and turn on the server.