Removing A 2.5-Inch Disk Drive Backplane - Lenovo ThinkServer TD200x Hardware Maintenance Manual

2. Touch the static-protective package that contains the disk drive to any unpainted
3. Remove the filler panel from the hot-swap drive bay, if one is installed.
4. Make sure that the tray handle is open; then, install the hard disk drive into the
5. Rotate the drive handle down until the drive is seated in the hot-swap bay and
6. Close the bezel (see "Closing the bezel" on page 153).

Removing a 2.5-inch disk drive backplane

To remove a 2.5-inch hard disk drive backplane, complete the following steps.
200
ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Hardware Maintenance Manual
metal surface on the server; then, remove the disk drive from the package.
hot-swap bay.
the release latch clicks into place.
Notes:
a. After installing the hard disk drive, check the disk drive status LEDs to verify
that the hard disk drive is operating correctly.
If the amber hard disk drive status LED is lit continuously, that drive is faulty
and must be replaced. If the green hard disk drive activity LED is flashing,
the drive is being accessed.
b. If the server is configured for RAID operation using an optional ServeRAID
adapter, you might have to reconfigure your disk arrays after you install hard
disk drives. See the documentation that was included with the optional
adapter for additional information about RAID operation.
1
Latch
2
Tabs
3
Configuration cable connector
4
SAS signal cable connector
5
2.5-inch hot-swap backplane
6
Power cable connector
7
Locator pin