Lenovo ThinkServer TD200x Hardware Maintenance Manual page 207

6
Bay 6
7
Bay 7
v For a list of supported optional devices for the server, see
http://www.lenovo.com/thinkserver.
v Inspect the drive and drive bay for signs of damage.
v Make sure that the drive is correctly installed in the drive bay.
v See the documentation for the ServeRAID controller for instructions for installing
a hard disk drive.
v All hot-swap drives in the server must have the same throughput speed rating;
using drives with different speed ratings might cause all drives to operate at the
throughput of the slowest drive.
v You do not have to turn off the server to install hot-swap drives in the hot-swap
drive bays. However, you must turn off the server when you perform any steps
that involve installing or removing cables.
v The drive ID for each hot-swap hard disk drive is printed above the drive bay.
1
Filler panel
2
Hard disk drive assembly
3
Release latch
4
Drive handle
To install a hot-swap hard disk drive, do the following:
1. Read the safety information that begins on page 5.
Attention: Static electricity that is released to internal server components
when the server is powered on might cause the server to halt, which might
result in the loss of data. To avoid this potential problem, always use an
electrostatic-discharge wrist strap or other grounding system when you work
inside the server with the power on.
Chapter 7. Installing optional devices and replacing customer replaceable units
14
Bay 14
15
Bay 15
199