Installing A 2.5-Inch Hot-Swap Hard Disk Drive - Lenovo ThinkServer TD200x Hardware Maintenance Manual

2. Open the bezel (see "Opening the bezel" on page 152).
3. Press down on the release latch to open the drive handle; then, pull the drive
4. If you are instructed to return the hot-swap hard disk drive, follow all packaging

Installing a 2.5-inch hot-swap hard disk drive

The following notes describe the types of hard disk drives that the server supports
and other information that you must consider when you install a hard disk drive:
v Depending on the model, the server supports up to eight or up to 16 2.5-inch
v The hot-swap bays are arranged horizontally in the top and bottom hard disk
198
ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Hardware Maintenance Manual
Attention: Static electricity that is released to internal server components
when the server is powered on might cause the server to halt, which might
result in the loss of data. To avoid this potential problem, always use an
electrostatic-discharge wrist strap or other grounding system when you work
inside the server with the power on.
out of the drive bay.
instructions, and use any packaging materials for shipping that are supplied to
you.
SAS hot-swap hard disk drives in the hot-swap bays.
drive cages:
– On models with eight hard disk drives, the top bays are numbered 0 through 7
(from right to left)
– On models with 16 hard disk drives, the top bays are numbered 0 through 7
(from right to left) and the bottom bays are 8 through 15 (from right to left)
0
Bay 0
1
Bay 1
2
Bay 2
3
Bay 3
4
Bay 4
5
Bay 5
8
Bay 8
9
Bay 9
10
Bay 10
11
Bay 11
12
Bay 12
13
Bay 13