Installing A 2.5-Inch Disk Drive Backplane - Lenovo ThinkServer TD200x Hardware Maintenance Manual

Installing a 2.5-inch disk drive backplane

To install a 2.5-inch hard disk drive backplane, complete the following steps:
202
ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Hardware Maintenance Manual
1
Latch
2
Tabs
3
Configuration cable connector
4
SAS signal cable connector
5
2.5-inch hot-swap backplane
6
Power cable connector
7
Locator pin
1. Touch the static-protective package that contains the hard disk drive backplane
to any unpainted metal surface on the server; then, remove the backplane
from the package.
2. Position the 2.5-inch hard disk drive backplane in the drive-cage retention tabs;
then, rotate the top of the backplane toward the locator pins until the latch
clicks into place
3. Connect the power, signal, and configuration cables to the 2.5-inch hard disk
drive backplane (see "2.5-inch hard disk drive backplane connectors" on page
149 and "Internal cable routing and connectors" on page 165).
4. If you are replacing another 2.5-inch hard disk drive backplane, repeat steps 1
through 3 to install the additional backplane.
5. Install the hot-swap hard disk drives (see "Installing a 2.5-inch hot-swap hard
disk drive" on page 198).
6. Close the bezel (see "Closing the bezel" on page 153).
7. Install the fan-cage assembly (see "Installing the fan-cage assembly" on page
174).
8. Install the air baffle (see "Installing the air baffle" on page 172).
9. Return the power-supply cage to its closed position (see "Closing the
power-supply cage" on page 162).