Lenovo ThinkServer TD200x Hardware Maintenance Manual page 202

14. If the tape drive came with screws, secure the drive to the server chassis,
15. Connect one end of the tape drive cable to the USB or SATA connector on the
16. Connect the power cable to the tape drive and to the connector on the system
17. Reinstall the fan-cage assembly.
18. Reinstall the air baffle ("Installing the air baffle" on page 172).
19. Reinstall or close the power-supply cage ("Closing the power-supply cage" on
20. Reinstall the power supplies ("Installing a hot-swap power supply" on page
21. Replace the left-side cover; then, lock the side cover and bezel.
22. Reconnect the external cables and power cords.
194
ThinkServer TD200x Types 3719, 3821, 3822, and 3823: Hardware Maintenance Manual
using the supplied screws.
1
SATA optical drive power connector
2
USB signal cable connector
3
USB signal cable
4
SATA optical drive power cable (SATA-to-traditional power connector cable also
included. Not pictured.)
5
SATA optical drive signal cable
system board, depending upon the type of tape drive that you are installing;
then, route the cable through the cable holders on the inside of the server and
connect the opposite end of the cable to the back of the tape drive.
Note: If you are installing an RDX internal USB tape drive, use the
SATA-to-traditional power converter cable to serve as a bridge between the
optical power cable and the power connector on the RDX tape drive.
board (see "Internal cable routing and connectors" on page 165 for more
information.)
page 162).
177).