Installation Instruction - 4IPNET WHG315 User Manual

Installation Instruction

Preparations
1. Unpack the WHG Controller and go through the package checklist.
2. Review the front panel and back panel and identify each control and network
interface that is described in the Hardware & Specification section.
3. Prepare Ethernet cables with RJ-45 connectors.
4. Prepare a PC with Web browser for accessing the Web Management Interface.
5. Identify an upstream device for WHG Controller to connect to your network, such
as ADSL, CABLE modem or other edge devices. Collect the DNS server address
provided by your ISP.
Installation
1) Connect the power adaptor or power cord to the power socket on the rear panel.
The Power LED should be on to indicate a proper connection.
2) Connect an Ethernet cable to the WAN1 Port on the front panel. Connect the
other end of the Ethernet cable to an xDSL/cable modem, or a switch/hub of an
internal network. The LED of this port should be on to indicate a proper
connection.
3) Connect an Ethernet cable to a LAN Port on the front panel. Connect the other
end of the Ethernet cable to an administrator PC for configuring the system. A
switch can be used to connect multiple devices to the LAN port of the Controller.
NOTE
1. It is highly recommended to use all the supplies in the package instead of
substituting any components by other suppliers to guarantee best performance.
WHG Controller / HSG Gateway
228
User's Manual
ENGLISH