D) Adding - 4IPNET WHG315 User Manual

allow the administrator to remotely configure the AP's SNMP community.

Discover: When the administrator tries to discover a new AP, select the Device Type. Second, enter the
current IP range of the APs, Login ID and Password. Then click Discover button. If the new AP is
discovered, it will appear in the following Discovery Results list. The administrator may stop the
controller from scanning at any time during the discovery process.

Device Results: The discovery new APs will be listed here. The administrator can click Add to register
the APs to the List for management.
When the discovery process is complete, the APs found will be listed under the Device Results table. Here
the administrator can specify the individual AP's Device Name and SNMP Community string. Click the
Add button and the discovered APs will be added into List.

d) Adding

The Adding function is used to manually set up an AP via filling in the required information for that AP.
Besides the Discovery feature that can search and list multiple APs for adding to the management list,
administrators can also select Add an AP to directly add a single Access Point to the management list.
Simply configure the devices IP address, name and login credentials, set a SNMP community string and
click the Apply button.
The administrator can add supported APs onto the List table manually here. A manually added AP will
show up with a status of "offline" in the AP List initially. The system will attempt to connect to the AP by
SNMP protocol. After successful SNMP Reads, the manually added AP will become online.

Device Type: The device type of Wide Area APs.

Device IP: The IP address of the AP to add to the management list.
WHG Controller / HSG Gateway
312
User's Manual
ENGLISH