Hardware Overview - 4IPNET WHG315 User Manual

Hardware Overview

WHG311 Hardware
1 Quick
Buttons
2 LED Displays
3 WAN1/
WAN2
4 LAN1~ LAN8
5 USB
6 Console
Reset: Press and hold the Reset button for over 3 seconds and status of
LED on front panel will start to blink, release button at this stage to restart
the system. Press and hold the Reset button for more than 10 seconds and
status of LED on the front panel will turn from blinking to off, release at
this stage to reset the system to default configuration.
Quick-Restore: This button is the firmware switch button. Press this
button while system is powering up and release when the "Quick-Restore"
LED lights up, the system will switch to the other firmware image and boot
up with that firmware.
Quick-VPN: This button is for establishing a site to site VPN tunnel with
minimal pre-configurations at a push of a button. Please refer to
"Appendix: Hardware Button" for detailed operation instructions.
Quick-Maintenance: This button allows admin to copy an exact FW &
Config from controller A to controller B except for MAC address. Please
refer to "Appendix: Hardware Button", for detailed operation instructions.
Power: Power LED lights up as constant green when power supply is on.
Status: Status LED is Blue. Blinking indicates that system OS is booting
up, when lit up constantly it indicates that the system is ready for
operation.
Quick-Restore: This is used to indicate that the system will now switch to
the other F/W partition for operation.
Quick-VPN: This LED is used for indicating the status of establishing site
to site VPN tunnel with minimal pre-configurations at a push of a button.
Please refer to Appendix F for detailed status description.
Quick-Maintenance: This LED is for indicating the status of copying FW &
Config from controller A to controller B except for MAC address. Please
refer to "Appendix: Hardware Button" for detailed status description.
Two WAN ports (10/100/1000 Base-T RJ-45) for uplink connections to the
external network, such as the ADSL Router from your ISP (Internet Service
Provider).
Client machines or switch connect to WHG311 via LAN ports (10/100/1000
Base-T RJ-45).
Function Reserved for future use.
The system can be configured via a serial console port. The administrator
WHG Controller / HSG Gateway
218
User's Manual
ENGLISH