Quick-Restore - 4IPNET WHG315 User Manual

User's Manual
WHG Controller / HSG Gateway ENGLISH

16.2.1. Quick-Restore

There will be two firmware images on the system, denoted as FW1 and FW2
bundled to configuration db, denoted as Config1 and Config2 respectively.
During system power up, the system will boot up with the FW+Config which is
run in the last operation.
1) Pressing the "Quick-Restore" button
When the "Quick-Restore" button is pressed while the system power is on, the
boot up option will be switched. Press this button while system is powering up
and release when the "Quick-Restore" LED lights up, the system will switch to
the other firmware image and boot up with that firmware.
Case1: When FW1+Config1 is the last in operation FW+Config, pressing the
"Quick-Restore" button will switch the operation to FW2+Config2. Successive
reboots without pressing the "Quick-Restore" will trigger the system to run with
FW2+Config2.
201