Portal Customization - 4IPNET WHG315 User Manual

User's Manual
WHG Controller / HSG Gateway ENGLISH
3. PPP dial-up authentication
Point-to-Point Protocol (PPP) is a data link protocol commonly used in establishing a
direct connection between two networking nodes. When this feature is enabled for
service, end users may configure a dial-up connection setting with a valid username
and password (support only Local and RADIUS users). Once the dial-up connection
has been established, the user would have been authenticated successfully without
further UAM login.
The IP Address Range Assignment field configures the starting IP range which
PPP can assign IP addresses to dial-up virtual interfaces. The assigned interface IP
address is used to route between the networks on both side of the tunnel.

6.2.6. Portal Customization

Configuration Path: Main Menu >> System >> Service Zones >> Configure
Each Service Zone can be configured to have unique Login Pages or Message Pages.
There are 3 types of Login Pages: The General Login Page, PLM Open Type Login
Page (for Port Location Mapping free access), and PMS Billing Plan Selection Page. A
80