Hardware Installation - 4IPNET HSG1250 Quick Installaion Manual

Hardware Installation

Please follow the steps mentioned below to install the hardware of HSG260:
1. Place the HSG260 at a best location.
The best location for HSG260 is usually at the center of your wireless network.
2. To supply power over to HSG260.
Connect the DC power adapter to the HSG260 power socket on the front panel.
(a)
Please only use the power adapter supplied with the HSG260
package. Using a different power adapter may damage this
system.
3. Connect HSG260 to your outbound network device.
Connect one end of the Ethernet cable to the WAN port of HSG260 on the rear panel.
Depending on the type of Internet service provided by your ISP, connect the other end
of the cable to the ATU-Router of an ADSL, a cable modem, a switch or a hub. The
WAN LED indicator should be ON to indicate a proper connection.
4. Connect HSG260 to your network device.
Connect one end of the Ethernet cable to the LAN1 port of HSG260 on the rear panel.
Connect the other end of the cable to a PC for configuring the system. The LAN1 LED
indicator should be ON to indicate a proper connection.

Note:
Now, the hardware installation is completed.
To double verify the wired connection between HSG260 and your
switch/router/hub, please check the LED status indication of these
network devices.
Copyright © 4IPNET, INC. All rights reserved.
HSG260 has two virtual zones Private and Public which are mapped to
LAN1/LAN2 (192.168.1.254) and LAN3/LAN4 (192.168.11.254)
respectively.
HSG260 Wireless Hotspot Gateway ENGLISH
4
Quick Installation Guide