Service Zones - 4IPNET WHG315 User Manual


Status: This feature can be turn on or off here.

Number of Active(s): Selecting up to 3 Actives for N+1 HA

Mode: The role of this particular controller must be determined here manually.

HA Port IP Address: The IP address configured for the dedicated HA port. Should make sure
that all controller's HA port IP are under the same subnet.

HA Port Subnet Mask: The subnet mask for HA communication.
Peer IP Address: Fill in the IP address of the peer Controller's HA port.


Shared Key: Enter a secret string on both of the controller. The Shared Key must be the same
for a successful HA connection.

Action: This function may be triggered on the primary controller, switching service to the
secondary controller manually. (available on 1+1 HA only)

Dedicated Port: Currently LAN1 for all Controller models.

Status: Reflects the current status of the HA link.

Version: Shows the HA feature revision.

6) Service Zones

The table will list the Service Zones and related settings.
DHCP Server: The system supports three types of DHCP modes; Disable Built-in DHCP Server,
Enable Built-in DHCP server, and Enable DHCP relay. Select Disable Built-in DHCP Server to
disable the built-in DHCP server when clients are assigned static IP addresses. Select Enable Built-in
DHCP Server to enable the built-in DHCP server. When the built-in DHCP server is chosen, the system
will act as a DHCP server and assign IP addresses to its clients. Select Enable DHCP Relay when a
service zone is connected to an external DHCP server. When Enable DHCP Relay is chosen, the IP
WHG Controller / HSG Gateway
265
User's Manual
ENGLISH