Download Print this page

Epson Stylus COLOR 800 Service Manual: Printer Mechanism Removal

Hide thumbs

Advertisement

EPSON Stylus &2/25 800

3.13 Printer Mechanism Removal

1. Remove the units and assemblies by following the procedures described in Section 3.9.
2. Disconnect all the connectors and FFCs from the C202 MAIN board assembly.
3. Remove 4 screws (CB, 4x12, F/Zn) securing the printer mechanism to the lower case.
(Refer to Figure 3-37.)
Figure 3-37. Printer Mechanism Screw Removal
4. Lift up the printer mechanism to remove it from the lower case.
Make sure the connectors are not cut when you install the printer mechanism.
Always hold the upper or rear part of the mechanism, and never touch the gears.
Do not forget to insert the sub ink drain pad into the printer mechanism before installing
the mechanism into the lower case. The mounting location is shown in Figure 3-38.
Tightening torque for the screws (CB, 4x12, F/Zn) = 4 ~ 5 kg-cm.
3-30
Download Service Manual and Resetter Printer at http://printer1.blogspot.com
Rev. A

Advertisement

Chapters

Troubleshooting

   Also See for Epson Stylus COLOR 800

   Related Manuals for Epson Stylus COLOR 800

Comments to this Manuals

Symbols: 0
Latest comments: