Input Of Customer Data - Epson Stylus COLOR 800 Service Manual

4.2.2

Input of Customer Data

This operation is required when the C202 MAIN board is replaced. The program for this adjustment is
used to write the Customer data (set for each destination) into the EEPROM on the ASP C202 MAIN
board. If this program is not properly operated, it might cause failure in reading CG data and installing
various types of utility using Bi-directional interface. The procedure for this operation is described below.
; Customer data writing is programmed to be performed ahead of other adjustments. Therefore you
cannot proceed to any other adjustments without executing this operation first.
1. Set this program to FFD on your PC and turn the PC on.
2. The program automatically sets up and the following menu appears on the screen.
3. Enter "1" for "Select menu :?" to select "Input of Customer data" in the menu.
4. Press "ENTER" key, and the menu below appears.
5. Enter the 4-column code which corresponds to the destination for "Memory-SW data (4 col data)"
and press "ENTER" key. The customer codes for each destination is listed below:
6. After performing necessary adjustments, store the setting values in the EEPROM on the C202 MAIN
board by selecting and performing "Print Inspection" in the sub menu.
Rev. A
Download Service Manual and Resetter Printer at http://printer1.blogspot.com
Stylus COLOR 800 J70C00E
Customer : Standard Customer DATA < **** > 12-03-1996
Input Customer data
Adjustment/Print inspection
Changing of center value
........................
Input of comment
..........................
Change of date
..........................
Change of time
END
Select Menu ?_
Figure 4-6. Main Menu
Stylus COLOR 800 J70C00E
Customer : Standard Customer DATA < **** > 12-03-1996
Input Customer data
Adjustment/Print inspection
Changing of center value
........................
Input of comment
..........................
Change of date
..........................
Change of time
END
Select Menu : 1
Input the customer data
Memory-SW data (4col data) : ?
Figure 4-7. Input of Customer Data
0000 : EAI, EAI (Latin)
0101 : EDG (NLSP) EDG (NLSP)
0001 : Europe Standard (EDG, EFS, EIS, EIB, EUL)
.....................
1
..............
2
................
3
4
5
6
9
.....................
1
..............
2
................
3
4
5
6
9
Adjustment
4-7