Download Print this page

Epson Stylus Color 800 Quick Setup Manual

Epson stylus color 800: quick setup.
Hide thumbs
   

Advertisement

Unpack the Printer

paper
support

Quick Setup

Here's how to set up your new EPSON
Remove any packing material from the printer, as described on
the Notice Sheet in the box. Save all the packaging so you can
use it if you need to transport the printer later. You'll find these
items inside:
black ink
cartridge
Place the printer flat on a stable desk near a grounded outlet.
Leave plenty of room in back for the cables and enough room
in front for opening the output tray.
Do NOT put the printer:
In an area with high temperature or humidity
In direct sunlight or dusty conditions
Near sources of heat or electromagnetic interference, such
as loudspeakers or cordless telephone base units.
Also, be sure to follow the Safety Instructions in the
Introduction of your User's Guide.
®
printer . . .
color ink
cartridge
4006677

Advertisement

   Related Manuals for Epson Stylus Color 800

   Summary of Contents for Epson Stylus Color 800

  • Page 1: Quick Setup

    Quick Setup Here’s how to set up your new EPSON Unpack the Printer Remove any packing material from the printer, as described on the Notice Sheet in the box. Save all the packaging so you can use it if you need to transport the printer later. You’ll find these...

  • Page 2: Attach The Paper Support

    Insert the paper support in the top slot on the back of the printer. First make sure the power is off. Check the it’s off when its surface is raised above the printer surface. Plug the power cord into a properly grounded outlet. power button;...

  • Page 3: Install The Ink Cartridges

    If ink gets in your eyes, flush them immediately with water. Lower the output tray and raise the printer cover. Press the power button to turn on the printer. The light flashes, the cartridge holders move to the left.

  • Page 4

    Never turn off the printer when the power light is flashing. up and the arrow pointing toward the back of the printer. 6. Push down the clamp until it locks in place. 7. Press the color cleaning button. The print heads move to the left again so you can install the color ink cartridge.

  • Page 5: Load The Paper

    Load the Paper Note: Don’t load paper above the arrow mark inside the left edge guide. 1. Slide the left edge guide all the way left and pull out the output tray extensions. 2. Fan a stack of plain paper and then even the edges. 3.

  • Page 6: Connect The Printer To Your Computer

    Pages showing a nozzle check pattern and samples of fonts and colors begin to print. 3. Turn off the printer to end the test. If you have any problems with the test, see Chapter 6 in your User’s Guide for more information.

  • Page 7: Connecting To A Macintosh

    Now you need to install the printer software so you can control printing from your computer. You must install the software for the printer to work correctly. See the instructions included with your EPSON printer software CD-ROM or diskettes. on your Macintosh.

  • Page 8

    See Your EPSON Documentation EPSON is a registered trademark and EPSON Stylus is a trademark of SEIKO EPSON CORPORATION. General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners. EPSON disclaims any and all rights in those marks.

Comments to this Manuals

Symbols: 0
Latest comments: