EPSON Stylus &2/25 800
4. Remove 4 screws (CCP, 4x12, F/Zn): 2 screws securing the upper housing to the front and
2 screws securing the upper housing to the top rear side of the printer.
(Refer to Figure 3-6.)
5. Set the platen gap lever to the "+" position. Then, pull the front part of the upper housing
forward, and lift it backward to remove.
Before installing the upper housing, set the platen gap lever to the "+" position to make
the job easier. You must set it back to "0" after theu upper housing is securely positioned.
Tightening torque for the screws (CCP, 4x12, F/Zn) = 10 kg-cm.
Download Service Manual and Resetter Printer at http://printer1.blogspot.com
Figure 3-6. Upper Housing Removal