Removal Of Platen Unit And Paper Guide; Removal Of Printer Mechanism - Epson LX-HOO Technical Manual

3. Remove the five screws securing the ROC filter unit to the base plate.
The screws are as follows:
1 X C.B.O. (M4 X 8)
1 X C. T. B.S.(O) (M4 X 8)
2 X C.T.B. (M4
X 14
X C. T. P.S.(O) (M3 X 6)
1
4. Remove the ROC filter unit (including the AC cable (120 V), AC

4.2.4 Removal of Printer Mechanism

This section describes the platen unit, paper guide, and printer mechanism removal. Before removing
the printer mechanism, remove the platen unit and the paper guide so that the printer mechanism can
be removed quickly and easily.
4.2.4.1 Removal of Platen Unit and Paper Guide (Figures 4-8 through 4-9)
1. Remove the upper case. (Refer to Section 4.2. 1.1)
2. Turn the shaft holders at the left and right sides of the platen unit as shown
the platen unit to remove it.
a. Push the shaft holder outward using a screwdriver.
b. Turn the shaft holder counterclockwise.
Fig. 4-7. Printer Mechanism Removal
Frame
(Left
Side)
/
Fig. 4-8. Platen Unit Removal
4-7
and power switch).
inlet (220/240 V),
in Figure 4-8, and
ten
REV.-A
lift