Printer Mechanism Removal - Epson Stylus Photo 895 Service Manual

EPSON Stylus PHOTO 895/785EPX
When attaching the waste drain inkpad, check that the tip of
waste ink tube is correctly placed at the specified position of
waste drain inkpad. If the waste ink tube is not correctly
attached, ink leakage may occur. Refer to Figure 4-20. "Tip of
the waste ink tube setting position".
Waste Drain Inkpad
Figure 4-20. Tip of the waste ink tube setting position
When the Waste drain ink pad is replaced with a new one,
following service item is required.
Waste drain ink counter reset operation.
Disassembly and Assembly
Ink Tube
Disassembly

4.2.7 Printer mechanism removal

1. Detach the housing from the printer. (Refer to Section 4.2.1 "Housing Removal")
2. Detach the printer panel from the printer. (Refer to Section 4.2.2.1 "Printer Panel
Board Removal")
3. Remove the Sub Left Panel and left housing lower cover from the printer. (Refer
to Section 4.2.3.1 "Housing Lower Cover Left Removal")
4. Remove five screws as shown here.
C.B.S 3x6 F/ZN
Figure 4-21. Printer mechanism removal
Revision A
C.B.P 3x8 F/ZN
C.B.S 3x6 F/ZN
84