Epson Stylus COLOR 800 Service Manual page 131

5. Enter the 4-column code which corresponds to the destination for "Memory-SW data (4 col data)"
and press "ENTER" key. (See the code list on Page 4-6.)
6. Enter "2" for "Select menu : ?" to select "Adjustment/Print inspection" in the menu.
7. Press "ENTER" key, and the sub menu below appears.
8. Enter "1" for "Select menu : ?" to select "Write to the Head voltage value" in the menu.
9. Press "ENTER" key, and the following appears.
10. Input the correct head voltage with 5 colums and check if the head voltage value was input on the
confirmation menu which is shown on the screen. If correct, press "ENTER" key. If incorrect, press
"SPACE" key and replace the incorrect value with the correct one.
Rev. A
Download Service Manual and Resetter Printer at http://printer1.blogspot.com
Stylus COLOR 800 J70C00E
Customer : Standard Customer Data < **** > 12-03-1996
..............................
Ink charge
Write to the Head voltage value
..........................
.............
All adjustment
.............
Head angular adjustment
BK.-M Linear adjustment
Head GAP timming adjustment .....................
Bi-d adjustment
......................
Print inspection
........................
Ink discharge
Customer data change/End
Select Menu ?_
BI-D (center value 0,0)
Gap Timming (center value 0,0)
Figure 4-13. "Adjustment/Inspection" Sub Menu
<<<< Write the HEAD Voltage value>>>>
Black Head voltage
Black voltage value (5chr. ID data (ex.18A09)) :
----Voltate value----------------------
Black voltate value :
Color voltage value :
Figure 4-14.
"Write to the Head Voltage Value"
0
.......
1
2
3
.......
4
5
6
7
8
...........
9
Adjustment
4-11