Download Print this page


6. Remove 2 FFCs from the printheads. (See Figure 3-10.)
7. Shift the printheads forward. Then remove them by lifting upward carefully.
In handling the printheads, note the following:
‰ Ground yourself. The driver IC is attached directly to the printhead unit.
‰ Do not touch the printhead surface.
Before installing a new printhead in the CR assembly, note the voltage ID stamped on
the right side of the printhead.
When tightening and loosening printhead fixing screws, use your hand to support the
bottom of the CR assembly.
Rev. A
Download Service Manual and Resetter Printer at
Figure 3-10. Head FFC Removal
Disassembly and Assembly




   Also See for Epson Stylus COLOR 800

   Related Manuals for Epson Stylus COLOR 800

Comments to this Manuals

Symbols: 0
Latest comments: