Epson Stylus COLOR 800 Service Manual page 71

EPSON Stylus &2/25 800
3. Disconnect all cables (CN4, CN6, CN7, CN8, CN11, CN12, and CN13) and FFCs (CN9 and
CN10) from C202 MAIN board assembly. (See Figure 3-4) Use instructions below to
disconnect connectors:
‰
CN11, CN12, CN13:
‰
CN4:
Remove C202 MAIN board from the printer main board slot. (See Figure 3-3.)
Note the direction when connecting cables for CN11, CN12, CN13, and CN4. Be sure to
insert the pin 1 side into the position marked with a "1" on the board.
Ensure that the locks for CN11, CN12, CN13 are locked after connection.
Hold down the lock lever for CN4 while connecting the cable.
Make sure no cables or FFCs are cut by the shield plates.
Tightening torque for the screws (CBS, 3X8, F/Zn) is 8 ~10 kg-cm.
3-6
Download Service Manual and Resetter Printer at http://printer1.blogspot.com
Release the connector lock lever by pulling it up, and
disconnect the cable.
Release the connector lock lever by pressing it down, and
disconnect the cable.
Figure 3-4. Connector Removal
Rev. A