Setting The Finisher; Setting The Paper Feed Device - Kyocera KM-2540 Service Manual

2JB/2JC
Maintenance
item No.

Setting the finisher

U246
Description
Provides various settings for the built-in finisher, if furnished.
Purpose
Adjusts the side registration cursor stop position if paper registration is poor or stapling is made outside the
specified area.
Setting
1. Press the start key.
2. Press [FINISHER B-IN].
3. Select the desired cursor position.
4. Change the setting using the cursor up/down keys.
Display
FRONT
REAR
END
5. Press the start key. The value is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.

Setting the paper feed device

U247
Description
Turns on motor and clutches of optional paper feeder.
Purpose
To check the operation of motors and clutches of paper feeder.
Method
1. Press the start key.
2. Select the item to be operated.
Display
DESK FEED
CLUTCH FEED
CLUTCH U
CLUTCH L
3. Press the start key. The operation starts.
4. To stop operation, press the stop/clear key.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
1-3-46
Description
Front side registration cursor stop
position
Rear side registration cursor stop
position
Trailing edge registration cursor stop
position
Motor and clutches
Paper feeder drive motor (PFDM)
Paper feeder conveying clutch (PFCCL)
Paper feeder paper feed clutch 1 (PFPFCL1)
Paper feeder paper feed clutch 2 (PFPFCL2)
Description
Setting
range
-4 to +4
-4 to +4
-4 to +4
Initial Change in
setting value per step
0 0.566 mm
0 0.566 mm
0 0.566 mm