Fitting The Scanner Wires; Fitting Requires The Following Tools - Kyocera KM-2540 Service Manual

(3-2) Fitting the scanner wires

NOTE
When fitting the wires, be sure to use those specified below.
Machine front: (P/N: 2C912360), gray
Machine rear: (P/N: 2C912350), black

Fitting requires the following tools

Two frame securing tools (P/N 302C968310)
Two scanner wire stoppers (P/N 35968110)
Procedure
1. Remove the screw and remove the scanner
wire drum gear.
2. Remove the stop ring and bush from the-
front of the scanner wire drum shaft.
3. Remove the scanner wire drum shaft
fromthe scanner unit.
Screw
Scanner wire drum gear
Figure 1-5-45
Bush
Scanner unit
Figure 1-5-46
Scanner wire drum shaft
Stop ring
2JB/2JC
Bush
1-5-25