Detaching And Refitting The Heat Roller - Kyocera KM-2540 Service Manual

Hide thumbs Also See for KM-2540:

Table of Contents

(5) Detaching and refitting the heat roller

Follow the procedure below to replace the heat roller.

1. Remove the fuser heater (see page 1-5-47).

2. Remove the heat roller separation claws

(see page 1-5-44).

3. Remove the front and rear heat bushes from

right fuser frame.

4. Remove the fuser gear Z46, front and rear

heat bushes from heat roller.

5. Replace the heat roller and install the roller

6. Refit all the removed parts.

Figure 1-5-90

Fuser gear Z46

Right fuser frame