Setting The Limit For The Ejection Section Of The Built-In Finisher; Checking The Operation Of The Dp Motors - Kyocera KM-2540 Service Manual

2JB/2JC
Maintenance
item No.

Setting the limit for the ejection section of the built-in finisher

U236
Description
If the machine is equipped with an optional built-in finisher, this mode sets whether A5R/B5R/5
size paper is output to the machine eject tray or not.
Purpose
If the machine is equipped with an optional built-in finisher and if paper jams occur due to curling of paper in
the built-in ejection section when two-sided copying onto A5R/B5R/5
mode is used to change the setting to ON to disable ejection to the machine eject tray.
Setting
1. Press the start key.
2. Select ON or OFF.
Display
ON
OFF
Initial setting: OFF
3. Press the start key. The setting is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.

Checking the operation of the DP motors

U243
Description
Turns the motors and solenoids in the optional DP on.
Purpose
To check the operation of the DP motors or solenoids.
Method
1. Press the start key.
2. Select the item to be operated.
3. Press the start key. The operation starts.
Display
DP FEED MOTOR
DP CONV MOTOR
DP REV MOTOR
DP RJ SOL
DP RP SOL
4. To stop operation, press the stop/clear key.
Completion
Press the stop/clear key when operation stops. The screen for selecting a maintenance item No. is displayed.
1-3-44
Description
Description
Does not eject to the machine eject tray.
Eject to the machine eject tray.
Motors and solenoids
Original feed motor (OFM) is turned on.
Original conveying motor (OCM) is turned on.
Original switchback motor (OSBM) is turned on.
Switchback feedshift solenoid (SBFSSOL) is turned on.
Switchback pressure solenoid (SBPSOL) is turned on.
" x 8 " size paper is performed, this
1/2 1/2
" x 8 "
1/2 1/2