Diamond Dust CW Kit Assembly Manual page 53

Section 8: Final Equipment Installation – Cont.
Step 7
Continue pulling the pull tube until the
antenna exits the other side of the guide
tubing..
Step 8
Install your receiver in the location you
established when balancing the aircraft in
Section 5.
Step 9
NOTE: Due to battery size, type, and weight,
It will be up to the end user to determine the
location and manner in which the battery will
be attached to the airframe. We have a few
suggestions on the plans but they are merely
Suggestions.
Install the battery in the location you
determined in Section 5. You may have to
slide the tank forward or backwards in order
to insert you battery at the desired location.
Step 10
Locate the 2-56 pushrod and nylon clevis.
Thread the nylon clevis onto the 2-56
pushrod about half way on to the threads.
Attach the clevis to your engine and
determine the correct length needed and
create a z bend at the servo arm.
NOTE: make sure your servo arm is in the
proper throttle position in respect to your
carburetor position.
53