Diamond Dust CW Kit Assembly Manual page 24

Section 1: Framing of the Airframe – Cont.
Step 25 – cont.
With the airframe bottom side up,
install the
4" x 4-5/8" x 1/16" balsa
sheeting, beginning at the TE and going
towards the nose, using thick CA.
After applying the second cross grain sheet,
you will need to determine if you will be
using a standard radio receiver or a spread
spectrum receiver.
If you will be using a spread spectrum
receiver you may skip the rest of step 23
and proceed to step 24.
24
Step 26
The antenna tube will be inserted in
center the four precut 3/32" holes found on both of
the main ribs. You will need to feed the
antenna tubing through the front holes first.
As shown below.
After centering the tubing through the front
holes, insert the remaining portion of tubing
In the rear holes.
Remember: the airframe should still be
upside down.